Venus Critical Care Patient Monitor For ICU,CCU,NICU
Venus Critical Care Patient Monitor For ICU,CCU,NICU
Specification
Configuration
5-lead ECG, SpO2, NIBP, TEMP, Resp, PR; Touchscreen, HDMI, Li-ion battery
Optional
12-Lead ECG, Masimo/Nellcor SpO2, IBP, C.O., EtCO2, Multi-gas, BIS, NMT;
Thermal Recorder, Wired/Wireless CMS, 4G module
· 15.6” High resulotion TFT LCD Touch screen
· 10 waveform display,up to 12-lead ECG analysis
· Powerful calculation(Hemodynamic,Dose,Oxygenation,Ventilation)
· MEWS(Modified Early Warning Score)
· Pacemaker detection
· ST & arrhythmia analysis(26 types)
· SpO2 support PVI and PI,low perfusion 0.2%
· Night mode, standby mode, venipucture mode
· Trolley/wall mount braket solutions
· Support BIS module, NMT module
· Wired/Wireless/4G connection, support HL7 protocol to HIS
· SpO2 pulse-tone modulation (Pitch Tone)
· VGA/HDMI support external display
· Graphical & tabular trend review
· Rechargeable Lithium-ion Battery
· 72 hours full disclosure wave review for each patient
Specifications
Physical Specification
Display
15.6” TFT Touch screen
Resolution: 1366 x 768
Number of traces: 10, up to 12 ECG waveforms
Dimension: 398×302×183mm(W×H×D)
Weight: < 7 kg under standard configuration
LAN: 1 standard RJ45 port
WLAN:IEEE 802.11b/g/n
USB: 2 USB connectors
HDMI: 1 HDMI monitor connnector
Output:1 connector for Nurse call,Defib Sync Analog Output
ECG
Lead type :3-lead,5-lead,12-lead(optional)
ECG waveform:2 channels,7 channels, 12 channels
Display sensitivity(wave gain):
1.25mm/mV(×0.125), 2.5mm/mV (×0.25), 5mm/mV (×0.5),
10mm/mV (×1.0), 20mm/mV (×2.0),40mm/mV (×4.0),
Auto
Wave sweep speed:
3.125mm/s, 6.25mm/s, 12.5 mm/s, 25 mm/s, 50 mm/s
Bandwidth
Diagnostic mode: 0.05Hz~150Hz
Monitor mode: 0.5Hz~40Hz
Surgery mode: 0.5Hz~25Hz
Strong filter mode: 5Hz~25Hz
CMRR>100dB
Notch: 50/60Hz notch filter can be set to on or off
Differential input impedance>5MΩ
Electrode polarization voltage range: ±400mV
HR range: 15 - 350 bpm
Baseline recovery time<3s after defibrillation (in monitor
and surgery mode)
Calibration signal:1mV (peak - peak), accuracy ±3%
RESP
Measurement method : Thoracic electrical bioimpedance
Measuring lead: Lead I, II
Wave gain: ×0.25, ×0.5, ×1, ×2
Respiratory impedance range: 0.5-5Ω
Respiration range: 0 - 150bpm
Baseline impedance: 500-4000Ω
Gain: 10 grades
Scan speed: 3.125mm/s, 6.25mm/s, 12.5 mm/s, 25mm/s
TEMP
Accuracy:±0.1℃ or ±0.2℃ °F(without probe)
Measurement range: 5~50℃ (41~122°F)
Channel:Two channels
Resolution: 0.1℃
SpO2
Measurement range : 0-100%
Parameter monitoring: Perfusion Index(PI)
Pleth Variability Index(PVI)
Resolution: 1%
Accuracy: ±2% or ±2bpm
Refreshing Rate: 1s
Pleth wave speed: 3.125mm/s, 6.25mm/s, 12.5 mm/s, 25mm/s
Masimo SET® SpO2(Optional)
Measurement range : 0-100%
Resolution: 1%
Accuracy: ±2%(70-100%, Adult/Pediatric,non-motion,
low perfusion);
±3%(70-100%, Neonate,non-motion);
±3%(70-100%, motion);
0-69%,unspecified
Refreshing Rate: 1s
Pulse Rate
Range: 30~300 bpm
Resolution: 1bpm
Accuracy: ±2bpm (non-motion)
±5bpm (motion)
Refreshing rate: 1s
NIBP
Measurement method : Automatic oscillometric method
Operating mode:Manual, automatic, continuous
Measurement unit: mmHg/kPa selectable
Typical measurement time: 20~40s
Measurement type: Systolic, Diastolic,Mean
Measurement range (mmHg)
Range of Systolic pressure: Adult 40-280
Pediatric 40-200
Neonatal 40-135
Range of Diastolic pressure: Adult 10-210
Pediatric 10-150
Neonatal 10-95
Range of Mean pressure: Adult 20-230
Pediatric 20-165
Neonatal 20-105
Measurement accuracy
Maximum average error: ±5mmHg
Maximum standard deviation: 8mmHg
Resolution: 1mmHg
Interval:1,2,3,4,5,10,15,30,60,90,120,180,240,480minutes
Overpressure protection: Software and hardware,
double safety protection
Cuff pressure range: 0-300mmHg
IBP(Optional)
Channel:2-channel or 4-channel
ART: 0 to 300 mmHg
PA: -6 to 120 mmHg
CVP/RAP/LAP/ICP : -10 to 40 mmHg
Measurement range: P1/P2 -50 to 300 mmHg
Resolution:1mmHg
Accuracy:
±2% or ±1mmHg, whichever is greater(without sensor)
Sensitivity: 5uV/mmHg/V
Impedance range: 300 to 3000Ω
C.O.(Optional)
Method: Thermodilution
Range: C.O.: 0.2 to 20 L/min
TB: 23 to 45 ℃
T1: -1 to 27℃
Accuracy:C.O.:±5% or ±0.1L/min,whichever is greater
TB,T1:±0.5℃ (without sensor)
Northern Mainstream CO2(Optional)
Measurement range: 0-19.7%,150mmHg, or 0-20kPa
Resolution: 0.1mmHg
Measurement accuracy
0 - 40 mmHg: ± 2 mmHg
41 - 70 mmHg: ± 5% of reading
71 - 100 mmHg: ± 8% of reading
101 - 150 mmHg: ± 10% of reading
Respiration rate: 3-150 bpm
Respiration rate accuracy: 1% ±1bpm
Warm-up time: 97% within 8s, full accuracy within 20s
Northern Sidetream CO2(Optional)
Measurement rage: 0-20%(0-150mmHg)
Accuracy: < 5.0% CO 2: ± 2 mmHg
> 5.0% CO 2: < 6% of reading
Respiration rate: 2 ~ 150 BPM
Respiration rate accuracy: 1% ±1BPM
Warm-up time: 97% within 45s, full accuracy within 10 min
Rise times(t10-90%): About 100ms, when flow is 100 ml/min,
adult water trap,1.5m sampling tube
Delay time: <3sec when flow is 100 ml/min, adult water trap,
1.5m sampling tube
Recorder (Optional)
Built-in, Thermal dot array
Horizontal resolution :16 dots/mm (25 mm/s paper speed)
Vertical resolution:8 dots/mm
Paper speed:12.5mm/s, 25 mm/s, 50 mm/s
Number of waveform channels: 3
Masimo ISATM Sidestream CO2 (Optional)
Warm-up time: Full accuracy within 10 seconds
Sampling flow rate: 50ml/min(+/-10/min)
Measurement Range: 0 -25%
Accuracy: 0~15% (±0.2% of the reading)
15~25%, unspecified
Rise time: 200ms,typical at 50ml/min flow rate
Total response time:
within 3 seconds (with 2 m Momoline sampling line)
AWRR Range: 0-150bpm
AWRR Accuracy:±1 breath
Masimo IRMATM Mainstream CO2 (Optional)
Measurement Range: 0 -25%
Accuracy: 0~15% (±0.2% of the reading)
15~25%, unspecified
Warm-up time: Full accuracy within 10 seconds
AWRR Range: 0-150bpm
AWRR Accuracy:±1 breath
Masimo Multi-gas ISA OR+/IRMA AX+ CO2 (optional)
Gas:CO2,N2O,HAL,ISO,ENF,SEV,DES with automatic
identification
Warm-up time: Full accuracy within 20 seconds for IRMA
AX+ CO2 Accuracy: 0-10%:±(0.2%+2% of the reading)
0-15%:±(0.3%+2% of the reading)
N2O Accuracy: 0-100%:±(2%+2% of the reading)
HAL,ISO,ENF: 0-8%:±(0.15%+5% of the reading)
SEV:0-10%: ±(0.15%+5% of the reading)
DES:0-22%: ±(0.15%+5% of the reading)
Agent identification time:<20s(typical<10s)
AWRR range: 0-150bpm
AWRR accuracy: +/-1bpm
Apnea time: 20~60s
Aspect BISx module(Optional)
Parameter Measurement:
BC: 0~30(Only limited to the combined use of an external
sensor with a BIS module)
EMG: 30~55dB(bar chart)with intensity between 30dB and
80dB(tendency chart)
BIS: 0~100
SQI: 0%~100%
SR: 0%~100%
SEF: 0.5Hz~30Hz
TP:40~100Db
EEG Measurement:
Input impedance>5MΩ
Noise(RTI)<2μV(0.25~50Hz)
Input signal range: ±1Mv
EEG bandwidth between: 0.25Hz~110Hz
NMT(Optional)
Microprocessor-controlled
Stimulation Mode: TOF, TOFS, PTC, 1Hz Twitch, 0.1Hz
Twitch ,DBS DBS3.3 and 3.2(Double Burst) , Tetanic
Stimulation (Burst), 5s – 50Hz or 100Hz
Output(accuracy±5% of full scale value)
Surface electrodes:
Constant current,0-60mA(0-12/18μC) up to 5KOhm.
Monophasic, 200μs or 300μs pulse width
Needle electrodes:
Constant current,0-6mA(0-0.24μC) up to 5KOhm.
Monophasic, 40μs pulse width
Acceleration transducer: Accuracy±5% of full scale value
Temperature sensor: Range 20.0-41.5℃(accuracy±5℃)
Operation Environment
Power: AC 100-250V, 50/60Hz
Temperature: 5-40℃
Humidity: <80%
Patient Range: Adult, Pediatric, Neonate
No reviews found